R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 11-21-2008 | 09:18 PM
  #4747  
Gary-D8's Avatar
Gary-D8
Tech Adept
iTrader: (5)
 
Joined: Sep 2008
Posts: 183
From: Australia
Default

Cheers Shane and everyone else. I appreciate the advice. I have heard that Mark is a good bloke to deal with and have been told excellent things about some of the power and incredible run times that the guys are getting with the MM Modded engines. I am a little hesitant to spend too much on this 7 port though as it will probably be used mainly as a backup motor for next year. I will definately replace the bearings front and rear though and check over the rest of the internals and carb and go from there.

Cheers,
Gary


Oh and MM, you've got mail.
Gary-D8 is offline