Originally Posted by
KREATOR1
larry, please include the parts number. thanks dude
There really is not any part numbers.
Just a quick tease of materials needed:
3/8 inch stainless steel pipe from the hobby shop (piece cut in length equal to the thickness of the plastic washer)
(this pipe's outer diameter is equal to the inner diameter of spur gears. the pipe's inner diameter is also equal to the outer diameter of the 61t spur gear side where the pin goes in)
stock 61 tooth spur (teeth cut off)(this part would be awesome if someone can machine an aluminum version that the screw holes could be threaded, then you would not need the nuts and the clearance would be that much better)
couple of 3mm x 6mm flat head screws
couple of 3mm thin nuts
spur gear of choice with holes to put screws through counter sunk.
Pictures still to come, I have to take the car apart again to take pictures.
Larry