Hey,
I am Joe and I am new to the forum, had a question or two regarding the HFP-20. I purchased the the programmer primarily to set the deadband on a couple of HS 5745MG's I bought to run the steering in my 5th scale car. That was self explanatory and it took longer to read the directions than to set the deadband. So, after that was done I was trying out a couple of the other options available. I noticed that I couldn't get a value on the overload tab. Is that because my servos are not G2? I also noticed that the speed was set to 1...out of a possible 64. Am I misunderstanding the values and assuming that the higher value is faster or is that the delay for the cycle of the travel. Would appreciate your input and thank you in advance for the help.