Originally Posted by
Tubaboy
My guess is that he wants to switch to 64P gears instead of 48P. I have a brushless system on my XXXs without any dremeling requirements. I'm using a Novak setup. What motor are you using that you need to dremel?
if you want to switch to 64p then just buy an 108t 64p Losi made gear, not a adaptor.
I was running Orion vortex 17.5 which should be shorter than a novak motor, endbell was touching the chassis and it makes motor crookit on the motor plate after I Dremeled it off I see motor was lower than my chasis.