Figured it out - the bearings on the diff that supports the outdrive weren't seated properly. in one of the holes there was a plastic dag that a hobby knife trimmed out and it's fine now.
Cheers
Originally Posted by
Ashley Cobb
Hi Guys,
Just putting together a new kit and the transmission is binding with the 2 halves together. I've tried loosening the screws but no luck. When one half is off it spins smoothly.
I remembered reading somewhere (possibly on rc-mini.net) about some plastic that can be sanded down if this occurs, but I can't for the life of me figure out where it is. I've built 2 kits before this one and didn't have this problem.
Any help much appreciated.
Cheers
Ashley