Originally Posted by
CraigM
how did you screw it in without a head on it
another option is to use a long 3mm set screw (nitro cars have them, check parts from mugen/kyosho) and a hex headed pillow ball
Just turn it into the alloy part with your fingers, and put your finger on the back of it in order to hold the threaded part still while you put the pillow ball in, once its finger tight, just nip it up with the 5.5mm driver.
I would prefer to get some long set screws but i have not found any, tobee craft do make long ones, RCModel have them, but my last order for parts was from RCMarket. Market only had short ones.