Originally Posted by
gortan
I have no doubt this method is good for nova and nova based engines from the remarks i've seen on this thread.
I'd like to know if it also good for picco based and sirio based engines...
Thanks...
This was the procedure recommended to me by a Kyosho/Sirio driver for the Evo2 engine.
I run picco based engines now, and it's a little different as I just use a very high idle (1/4 maybe) and too rich for the wheels to spin for a few tanks. then near race tune after that for 3-4 tanks. switch the rod and then you are ready to race. (I have one rod that I break all my engines in with and switch back to the new rod for racing because the rods really don't like the break in process)