R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 10-21-2008 | 05:24 PM
  #4562  
El Tigre's Avatar
El Tigre
Tech Regular
 
Joined: Aug 2008
Posts: 335
Default

Originally Posted by grizz1
Check the pressure feed nipple on the exhaust pipe. I had pipe once that had a blockage in there. No pressure was getting to the tank. Poke a piece of wire down the nipple or blow through it and make sure it is clear.
If it's blocked you will be running super lean and engine will start but won't keep running more than a few seconds.
Sometimes the fuel will squirt out of the carb throat when starting. Don't run your engine without the air filter for long though. Any dirt or dust down the carb throat is a recipe for disaster
You were on the money. There was a blockage in the nipple on the exhaust pipe and the nipple bolt on the fuel tank was leaking air as well. It running now but I ran out of daylight to start breaking it, but PROGRESS!!!!

Thanks. Will let you know how it goes. Below are some shots of my cats:









El Tigre is offline