R/C Tech Forums - View Single Post - ESC wiring
Thread: ESC wiring
View Single Post
Old 10-17-2008 | 04:23 PM
  #4  
RAST
Tech Master
iTrader: (8)
 
Joined: Dec 2006
Posts: 1,563
From: Brisbane
Default
Have reset the ESC and set the end points.

The motor runs some times and then not most times. I have been able to get it going but very slowly. It is brand new. Oiled the ends and wired it up.

I haven't another brushless motor to try.

Most times I have th hand turn the motor while under acceleration and only sometimes does it run?
RAST is offline  
Reply