Hello all, I just started with a fresh new setup and Im doing everything possible to get it done right this time
I went out on a limb and got the new D8 and also the Sirio S21 BK Evo3 STI. I have been lingering around this thread for a little bit and it seems the concensus is running the turbo button and a OS P3 plug with the Sirio 2013. Well, when I purchased my equipment at the time, I hadn't yet researched the pipe situation and was conviced by a very respected local to get "this pipe." I simply mentioned that Im most concerned with having adequate bottom-end. "This pipe" happens to be an Ofna 069. Hopefully this will get the job done
Regardless, I also got a few P3's to throw in it...
My question is, is the button that comes on the motor the satandard button, or the turbo? Hope fully turbo BECAUSE, when I went to remove the head, that crappy flathead screw they use must have been tightened by a not-so-crappy screwdirver!! I used the only practical driver I had, which seemed just fine, and jacked up the head of the screw a little. I didn't want to make matters worse so I didnt continue. Ok..
So either, I am going to wait and use someones flathead that would better fit it (and hopefully still get that one I messed up out) and run turbo/P3 or, hope like HELL that the one that is in IS the turbo button
Anyone that can clarify wich button comes stock please do! If that one screw can't come loose, i seriously have NO idea how it would be possible to remove it...And, if I absolutely cant, what standard plug should I run? BTW, I just bought a fresh gallon of OD 24% 11%Lube...