I set the RS to motor type 2, which is fwd/brk/rev. But when I tried to brake after throttle, the motor goes into reverse, skipping the brake completely. Anyone has encountered this before?
Also if I do setting using hotwire. Then do some changes using the speedo buttons. Then later on, back to hotwire, hotwire gives me an error when reading back the settings from the speedo.
"Unhandled exception has occurred in your application. If you click Continue, the application will ignore this error and attempt to continue. If you click Quit, the application will close immediately.
Value of '0' is not valid for "Value'. "Value' should be between 'Minimum' and 'Maximum'.
Parameter name: Value"
followed by many lines of code stuff....
Clicking "Continue" will show me the hotwire screen with all values at minimum.
