Originally Posted by
Qatmix
Ahh, its part no1 from the A-tree. Looking at the instructions it does come from the wheels. I dont ahve wheels at teh moment so I hope the Zen ones I have just bought will have the fitting..
I'm really looking forward to getting an F1 car running again..
The new one piece thrust bearing makes life simple. Slide the rim on and then load the bearing and washers. The outter part of the kit wheel is held in place by 2 small screws. All the outter rim really does is cosmetically cover the thrust bearing assembly anyway. I have Cross wheels that are put on that way. It would be nice if Tamiya made an assembly to remove the wheel and tire and leave the thrust bearing alone.