R/C Tech Forums - View Single Post - Cost Efficient Soldering Iron
Thread: Cost Efficient Soldering Iron
View Single Post
Old 09-24-2008, 09:24 PM
  #32  
gfx
Tech Adept
 
gfx's Avatar
 
Join Date: Mar 2008
Location: Long Beach, CA
Posts: 233
Default
Originally Posted by RobbieS
Yes that solder will work fine.

.062 is the diameter. I personally always use the thinnest solder I can find. Usually Kester Solder or the Radio Shack 60/40 if I run out of the Kester before I order more.
Yeah, I know... I looked for the largest gauge they had, but wasn't sure if it was large enough for the gauge of wire on the Novak ESC. Why do you use the thinnest you can find?

And they had silver solder... would that work any better, as far as limiting resistance?
gfx is offline  
Reply