Well i dont know what the hell to do about this thing, NO MATTER WHAT I DD the carb binds, i almost threw the thing in the bin today after hours of fiddling with it.

Engine is in an 8ight

Ive Tried:

Taking the carb apart checking for burs and rubbing the slide down with scotch brite and greasing it to hell - any heat and the slide binds.

Adjusting this thing every way possible, different length servo arms, different carb rotation positions and different ball linkage positions. No matter how good i get it when its cold - any heat and the slide binds.

Do i buy a new carb and risk the same shit all over again?

Or should i just buy a new kit with a conventional servo tray set-up, i know it wouldn't bind with a normal, straight set-up.