I just installed my new Venom Fail Safe onto my car and connected it to the throttle/brake servo which is a digital HiTech HS5925MG servo. The servo worked perfectly before I installed the fail safe. Well anyways, I hooked the failsafe up exactly how it says in the directions tested it out and it worked perfectly. Then I turned on the electronics and my radio and when I gave it throttle the servo didn't move at all, and when I gave it brake it only barely moved a few millimeters. I thought something was wrong with the fail safe so I took off the failsafe and plugged the servo directly back into the receiver like it was normally, turned everything on, and low and behold the servo didn't move at all except for a few millimeters when I give it brake and it was beeping extremely loud . Everything was fine until I installed the fail safe, now my 95 dollar servo is an expensive paper weight because of the Venom Fail Safe .

What can I do? Does the Venom fail safe not work with digital servos or something and is only supposed to be used with analog servos?

Please help me! I don't think HiTech will be able to do any waranty stuff for the servo because the damage was directly caused by the Venom fail safe and it's not a manufacturers defect or anything.