View Single Post
Old 08-27-2003, 07:03 AM
  #34  
Ang Hukom
Tech Initiate
 
Ang Hukom's Avatar
 
Join Date: Aug 2003
Location: Inside the Boxer...
Posts: 29
Default Re: Anyone Tried This

Originally posted by CustomfibreR/C
Just wondering if anyone else out there has gone to this extent of bearing maintainence.....(see pic below)

I totally dismantled a bearing and rebuilt it and even with one of the balls missing, which is lost in the carpet somewhere, the difference was absolutely amazing.

This thing just spins and spins 8 - 10 times longer than it did before the rebuild......

Takes a lot of patience to rebuild it though.....
Yeah, done that. Kinda tiring though and for me, quite tedious.

But there's a good way of cleaning your bearings (only traditional bearings - not the sealed ones) without having to go to this extent.

Here it is:

1. Get an empty film canister (you know, those 35mm camera film canisters made of plastic).
2. Half fill it with kerosene (or any weak solvent).
3. Put about 3 bearings at a time and shake it for about 5 mins.
4. Open the canister and see the dirt that came out of the bearings!
5. Now boil about 3 teaspoonfuls of clean motor oil (40W is good) in a small aluminum kettle.
6. Turn off the heat. Let cool for about 2 mins.
7. Put the cleaned ("shaken") bearings in this kettle and let it stay there until the oil total cools down and turns viscous again.
8. Take off bearings and wipe off excess oil with paper towels.

Now you have a perfectly clean and OILED set of bearings!

Try it!
Ang Hukom is offline  
Reply With Quote