Originally Posted by
Slideaway
Thanks for your info.
Curious that the caps on the speedo I have look like they are already bent and I only used a 4.5t for the first run test. And the speedo was not that hot.
Would you suggest me to replace the 3 built-in ones ?
I will put some additional Caps as well.
You know, 3.5t is a very common motor used on this track. Many thai drivers used to use it (either do I as I used to run among them).
4.0t is also largely used.
I will try step by step with maximum prudence !
Thanks once again.
Slide
It's not the speedo temp, but the cap temp which makes them bend.
And stress on the caps is super high when running 6 cells.
you can replace 'em if you are good in soldering but please make sure to use exactly the same caps again! (Gm part-#: 91539.M)
specs: (470microF, 16V, 105°C)