thanks freelance!
i have uploaded picture of the actual engine.. It's actually a VX-12. The shaft takes the knurled disk, then the flywheel and then the extended shaft nut. the clutch bell and bearing then go on this 'extender'.
if i use an engine with sg crank, will the same bearing and cluthbell fit? and will the clutchbell align with spur? dont want to end up too short or too long..
are all side exhausts compatible. i.e - one side exhaust header will fit all kinds of side exhaust engines??
any engine recommendation that has the same crank shaft type as the one in the picture, has side exhaust and slide carb?
thanks.