R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 09-08-2008 | 07:21 PM
  #4292  
22Racer's Avatar
22Racer
Tech Elite
iTrader: (67)
 
Joined: Mar 2002
Posts: 3,150
From: Wanamingo Mn
Default

Originally Posted by herb99
Ran my .25 Go in a truggy on the weekend and it ran great.
Something I noticed at the end of the 6 minute heats was there was a slight hesitation on stand still to take off, as though there was a delay of fuel going to the carb for a split second.
The tune was perfect, 3 second pinch test and good trail of smoke on the top end. Temps around the 115c or 230f range. Motor has done 3 litres of fuel (3/4 of a gallon).
I can't work out what could be causing the hesitation.
Any ideas?
Thanks
You could have your bottom too rich and top too lean. The shorter low speed needle would help too. It's pretty easy to do with a griner or dremel.

Rex
22Racer is offline