R/C Tech Forums - View Single Post - Anyone try out GRP's Engine Tooling System yet?
Thread
:
Anyone try out GRP's Engine Tooling System yet?
View Single Post
08-28-2008, 05:29 PM
#
3
wingracer
Tech Lord
iTrader: (
24
)
Join Date: Nov 2007
Posts: 13,738
Trader Rating
: 24 (100%
+
)
RB's system is outstanding but pricey.
You really don't need any tools though. An oven or hot plate (I use a burner on the stove) really is the best way to do it. Allows you to install the bearings without putting any stress on them.
Reply
wingracer
View Public Profile
Find More Posts by wingracer
View iTrader Profile