R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 08-27-2008 | 08:08 PM
  #4172  
Tabushi's Avatar
Tabushi
Tech Elite
iTrader: (1)
 
Joined: Feb 2003
Posts: 3,061
From: Chile - Southamerica
Default

Race Report : August 23th and 24th - 2008

Event : 8th Stage of the 2008 Chilean Offroad National Championship

Classes : 1/8th IFMAR Buggy and 1/8th Truggy

Track : XRC Racing Hobby - Chile

Practice Session : During the practices i managed to setup my buggy and truggy very good giving me a good amount of confidence over the race. This is my first race in my country after a couple of years and the hobby has evolved in a good way, so the competition its very fierce with a lot of fast drivers. The track its very technical with just a few spots to do passing moves.

Qualifying and Semifinals : I ended on the slowest group of the event in buggy and truggy, due to the fact that the qualy groups are pre-assigned based on your last stage result, and this was my first event in Chile this year so i ended on the last/slowest group. Being such a technical track with no wide sections, this became a problem due to the slow traffic so i did my best to qualify the best i could. In Buggy, ended the qualification process in 6th position overall, thats mean 3rd place on the B-Semifinal (IFMAR Tree system, same as used in worlds). And in Truggy on 4th place overall. In Buggy, during the semifinals i had some mechanical problems and when i was in 3rd position (only the first 5 go to the finals) i had to call the day, very sad. In truggy i managed to go to finals, starting in 2nd position.

Finals : Truggy class its something new for me, and i was amazed about how good the CEN Truggy goes. My GO .25 engine + EFRA 2047 GO Pipe gave me confidence to race hard on this one, 30 minutes finals. I did a very good start securing 2nd position from the beggining, but after couple mistakes i was in 4th-5th position by mid race. After my 3rd pit pass, i started to climb positions and got secured again in 2nd position. So, great end in 2nd position and very happy with the track and engine combo, only bad part was tyre selection, i think other choice would be better suited for the track, i used Bowties on qualies and wanted to test Losi's ones that went very good on practice, but ended giving me a loose rear end during finals.

Here you have couple pics, and a video that a friend did of my truck (pink one).










Video : http://revver.com/video/1134837/8th-...-championship/




Equipment used in Buggy : GO .21 5 ports 6.5mm restrictor - GO 2047 Pipe - VP PRO 803 Tyres - OS P3 Plug - Power Save Racing Air Filters - VP PRO Wing - VP PRO 3 Shoe Clutch System - Maxy's Fuel 30%

Equipment used in Truggy : GO .25 6 ports 7mm restrictor - GO 2047 Pipe - Proline Bowties on qualies, Losi XTT's on finals - Novarossi C4 plug - VP PRO Airfilters - M2C Racing 4 shoe clutch system - Maxy's Fuel 30%

cya guys !!, hope to do it better next time !!!
Tabushi is offline