R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 08-24-2008 | 01:25 PM
  #4121  
22Racer's Avatar
22Racer
Tech Elite
iTrader: (67)
 
Joined: Mar 2002
Posts: 3,150
From: Wanamingo Mn
Default
Originally Posted by chipo
Can someone give me some advice about shimming Go 7 port engine?

Thanks,
Chipo

If I was running 20% I would just use the aluminum shim (.25mm), it should run fine with both shims but I've ran 30% with just the one silver shim.

Rex
22Racer is offline  
Reply