Originally Posted by
fastharry
I'm looking for a new standard shaft motor for my HPI super nitro, and was really suprised when I logged into towers site.....there are only 7 or 8 i OS engines being offered,very few 12's...no CVr 18's or TZ's with standard shaft, no 5 port tz12....very little selection.......
Anyone know of a NPS std shaft engine?...
if you want with slide get the 18 tz pilot and get the std crankshaft, it will cost you 196
if you want it with rotary, get the pull version plus the backplate, cut the pin on the shaft with a dremel and you should be ok, for a total of 190
either way it is cheaper that getting the 12 tz and makind nps stad shaft slide or rotary!
good luck