Originally Posted by
Stagger2
It could, did you shorten the new ant., did you put it in or someone else? if you cut it, that will cause you problems each band has an optimal length that is best changing this is not a good idea, if when soldered in, the solder joint was bad or "cold" it would not make a good contact or a lick of solder could make contact elsewhere on the board itself causing the issue.
Chad O
Hey Stagger2, just to let you know your advise on checking the solder on the new antenna turned out to be the problem. There was a slight bit of solder right next to where the antenna area was. Once the solder was taken off the T3 was back to normal. Thanks for the idea.
