R/C Tech Forums - View Single Post - Trinity EXTECH .21
Thread: Trinity EXTECH .21
View Single Post
Old 07-29-2008 | 10:54 AM
  #474  
The Joker's Avatar
The Joker
Tech Master
 
Joined: May 2007
Posts: 1,522
From: Under The City, N.Y.
Default
Originally Posted by supralative
Wahooooooooo
Just got mine in today!!!!!!
As soon as the new clutch set arrives, I can drop it in.

Do you guys pull the backplate, carb, pinch bolt, etc....and put sealant around them?

Right now we got HI 90's LOW 100's.
What plug would you guys run around here now.
Odonnell 30% Race Blend fuel
No need to take anything apart &/or off the engine, just clean & seal around whatever when installed!

I always seal up around the carb pinch screw on both sides, around the high-end needle/inlet fuel nipple & around the carb where it meets the engine when installed... Best stuff on the market to use is ---> (((Lucky-7 Engine sealant)))
Last edited by The Joker; 07-29-2008 at 11:47 AM.
The Joker is offline  
Reply