I am about to finish the break-in on my new 5 port turbo and the carb has developed an issue. The slide (or throttle body) that moves in and out, gets stuck about halfway going back into the body of the carb itself causing the throttle to stick. I disassembled the carb and it seems as though there is burr that is catching the slide. I intend to send it back to racefactor and I am sure they will take care of it, but my question is this......Although the stock carb off of my stock engine (mach 427) is a bit larger, could I use this to continue with the break-in or will it be simply too big and cause damage?