R/C Tech Forums - View Single Post - RB Concept Engine Thread
View Single Post
Old 07-28-2008 | 07:54 AM
  #194  
dead1dave's Avatar
dead1dave
Tech Apprentice
 
Joined: Jan 2008
Posts: 66
Default

I figure .8 was a good starting point at least ....................with tuning these motors generally have you mostly seen the Idle tuned up then ? once the bottom end is set right ?

I had it set at almost 6 turns out for the one qualifier I was in but the low end throttle response was terrible ................BUT IT DID NOT HANG THE IDLE ........only thing is I then had to lean the top out because the thing was a dog all the way around the track ...............I didn't leave it that way because I thought I was going backwards with the needles . I this right ? Thanks so much for your quick response .
dead1dave is offline