R/C Tech Forums - View Single Post - RB Concept Engine Thread
View Single Post
Old 07-28-2008 | 07:40 AM
  #193  
Jamie Corrado
Tech Master
iTrader: (17)
 
Joined: Nov 2004
Posts: 1,600
From: >New York<
Default

Originally Posted by dead1dave
I have a quick question for you tuner guys .............I am now really close to getting this C6 tuned in that I posted I was struggling with a while back.

If after a full throttle run down the straight away the idle "hangs"after the throttle is closed it is "what" on the low end ....rich or lean ? My settings are 3.5 on top and 5.5 on the LSN with the carb set at .8 mm throttle opening .Runs decent and doesn't stall but you can tell the tune is off .

I have leaned out the LSN before and then turned the idle down but then it stalls now and then . Simple right ? Just raise the idle ........well then the rpm "hangs" again ...................have I not gone lean enough yet ? I am running 20% sidewinder with a RB6 plug . Thanks for the help guys !
Sounds like you have to richen up the bottom end a bit more.
.8 for idle opening is only a general number, don't hold to this. You should adjust as needed.
Jamie Corrado is offline