I started the break-in on my new 5pt. turbo today. I added the shim that came with the engine, runinng on 30%, using a p3 plug and a 0801 pipe. I am using the break in method discussed here on page 78. Man is this engine tight! Anyway.....it will not idle consistently unless the igniter is on. If I remove it, within 20 secs to a minute, it stalls. The temps are where they need to be (230-250). Any ideas????? I suffered through two tanks idling (having to restart alot), but now am ready to start putting it down and running and it just stalls out.