R/C Tech Forums - View Single Post - DX2 Antenna
Thread: DX2 Antenna
View Single Post
Old 07-08-2008 | 04:33 PM
  #4  
dubluv
Tech Apprentice
 
Joined: Jun 2007
Posts: 80
From: Edmonton, AB
Default

Those of you that have a Spektrum radio antenna bust, it is possible to change the antenna by yourself....only trouble is you run the risk of voiding your warrenty if you screw up anything else on the radio.

Look at the back of the DX, remove the screws
carefully separate the back plate from the radio.
(I have the DX3.0)The antenna is CLIPPED onto the board
carefully ulpug the antenna wire with your HANDS***no tools***


Now that the wire id disconnected, you can remove the antenna itself.

The antenna will be secured in the radio via a black housing. The housing is held in place with 1 screw, remove it and the antenna housing and antenna will both come out the top of the radio.

The antenna will separate from the housing at the point underneath the folding joint. Get a precision screwdriver and lift the holding tab of the antenna from the inside through the bottom.

The antenna can then be pulled and you can replace with new antenna if you can get Horizon to ship you one....

I did becase it would have cost me $65+ to ship from Canada with a tracking number and then they said that the turn around was 3-4 days. Not counting Canadian customs, I was looking at 8-10 weeks for a 12min repair WITH NO SOLDERING....

Boo to Horizon. If I could purchase the antenna assemblies from them, I would charge way less....
dubluv is offline