R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 07-01-2008 | 05:35 PM
  #3528  
yaright's Avatar
yaright
Tech Apprentice
 
Joined: Feb 2008
Posts: 94
From: Brandon, MS
Default

I just got the 25 and I'm installing a fioroni turbo twin and it seems like the flyhweel nut needs shim. Has anybody installed one on the 25? Will OFNA clutch bell (non vented) fit too?
I run a 25 with the fioroni turbo twin on a Losi 8t, even with two hard springs it comes in a little early, the turbo slider (2 pieces) will allow you too run three springs instead of two and works much better. However, be prepared to change the springs about ounce a gallon or so.
If your using the GO colet, you will have to shorten it as it protrudes through the flywheel.
yaright is offline