In an earlier post, that nobody responded to. I stated that my GO 7 port seized because one of the two clips that holds the piston bearing in place apparently shot out while the engine was running and scratched the piss out of the sleeve and piston. I had only 1.5 gal. through it. What causes this and how is it prevented or do I just have shitty luck? Anyways, I have a new P/S/R kit on the way and I can't get the damned main bearing out to replace it with a TKO ceramic. I have tried heating the case with no luck. I don't want to destroy the thing getting the stupid bearing out. Is there a tool out there that will get this F@*#ing bearing out?
