R/C Tech Forums - View Single Post - Mugen MTX-3
Thread: Mugen MTX-3
View Single Post
Old 08-05-2003, 04:55 PM
  #6932  
joseviejo
Tech Initiate
 
Join Date: Jan 2003
Location: San Juan, Puerto Rico
Posts: 46
Default
Originally posted by stefan
I run Speedminds with the 1 mm aluminum washer from the MTX2 prospec.
Do the wheel nuts screw in completely with the spacers? I just installed some spacers (about 0.8 mm thick) but I noticed that the nylon insert in the nut does not screw in completely. I am afraid the wheels will loosen up and fall off the car during racing.

Thanks

Jose
joseviejo is offline  
Reply