Yes, but the reverse is not possible. This means you cannot have a sensored-based esc with the option to run it in sensorless mode.
hmmm.. sounds like it's very promising. Have you by any chance tried the 120amp version on 1/8 scale applications? I'm wondering if it can handle higher voltage with the bigger can motors?
I only tried it a couple times on 4S in my MBX5T, but the motor in it was a 6 pole motor from Mega (ACn22/30/2). I will wait until I get a new motor to try out and test a few 2 pole XL motors on 4S. I like 6S and up, but the Xerun 120A only goes to 4S.