R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 06-23-2008 | 09:07 PM
  #3342  
sachoppers's Avatar
sachoppers
Tech Apprentice
 
Joined: Jun 2008
Posts: 93
Default
Originally Posted by higgs2ca
I just purchased a 3p .21 R. I have run about half a gallon through it and I am finding it doesn't have enough bottom end snap. I am running a Go 0801 pipe using TQ fuel. This is in an Xray conversion Truggy.
Any addvise would be greatly appreciated.
Thanks...
Try 1.1 springs...I had .9 in my hot bodies.
Nice good snap now. allows the engine to rev a bit more, before clutch hits
sachoppers is offline  
Reply