View Single Post
Old 06-11-2008, 08:25 PM
  #6  
C Verano
Tech Elite
iTrader: (1)
 
C Verano's Avatar
 
Join Date: Oct 2003
Location: Cali
Posts: 3,846
Trader Rating: 1 (100%+)
Default

Originally Posted by Taylorm View Post
Guys, how are the chrome spacers and washers used. Can't figure out how to get bell set with just a little lash........... http://i227.photobucket.com/albums/d...g?t=1213240295 http://i227.photobucket.com/albums/d...g?t=1213240469 bearing is just barely sticking out past end of crankshaft........

You have the clutch correct. Put the screw through the silver pieces with the flange on them. The shorter one should be long enough to make up the space on the shaft. If the bell has to much play use the shims to take some out.
C Verano is offline  
Reply With Quote