R/C Tech Forums - View Single Post - Tweaks for Nova P5XS?
View Single Post
Old 06-08-2008, 10:52 PM
  #5  
houston
Tech Prophet
iTrader: (96)
 
houston's Avatar
 
Join Date: Sep 2004
Location: Sherwood,OR
Posts: 15,844
Trader Rating: 96 (100%+)
Default

go buy a dynamite chrome header , that msr pipe has a short header and it is a top end pipe . trust me it will run 1 milllion percent better !!! i prefer the dynamite 086 pipe/header combo for most engines myself . (actually ofna 086 with the jammin header , its very brittle though) . also try the mugen light aluminum shoes with the 1.0 mm kyosho springs , i have seen many mugen springs break . yes scuff the shoes with a wire wheel on your dremel or 200 grit or higher sandpaper will do the trick . scuff the bell and the shoes . a little tip from your uncle mont
later , monty
as far as chris's mods , i have seen them run with him driving and they were definitely fast , just too bad he couldn't drive 'em . philip atondo did pretty good with one though . but i still beat em won 500$ !!!!
houston is offline