R/C Tech Forums - View Single Post - Go-Tech Engines Thread
View Single Post
Old 06-03-2008 | 02:20 PM
  #3023  
mdmaxx
Tech Adept
 
Joined: Jun 2006
Posts: 245
From: Hampstead, Md.
Default

Originally Posted by cherokee180c
What, that is insane!!!! I am using the same 7port with 053 pipe now in a Losi 8T and getting 11:30 with no insert! I get 13 minutes on a 7.5mm insert. These are not just test numbers I am pitting at 9:40 seconds with no problem even off the first pit stop where you ran a bit before the race starts in my 30 minute mains, so I only have to stop twice. I only have about 2 gallons on the motor right now though. I am using Byrons Gen 2 fuel, which runs very cool.

I also finished 2nd this week in the Amain after a flameout issue on the last lap due to the cars getting tangled up and I didn't rev it while the turn marshals were trying to separate. I did pit 3 times though just for safety. I had the A main won by almost 2 laps before I turned a 1 1/2 minute last lap where normal lap times are 34 seconds. We also had a bunch of top drivers there with 3 heats of truggy. In fact, I have a PTM modified .25 6port coming, but I am not going to throw it in the truggy right away as long at this stock 7 port is winning!!! I only added this information if you think I am crazy telling you those run times. They are very real, so I would go back and find out why your run times are so off.
he's right i was pitting for 2 guys in that same main.
mdmaxx is offline