Yea I don’t like using red loctite on anything but the blue didn’t work for us either on those screws. We also use the red loctite on the throttle linkage set screws and that is it as far as I can remember. Every where else is blue if we need it. Just don’t forget to heat up the aluminum or you may strip or break something trying to get those screws loose with the red lock tight.
The 2t3s should make the truck rotate better on throttle but if the track is really bumpy you may want and try less anti-squat. That will allow the truck to go through the bumps better on throttle but it may also give too much rear traction on throttle and cause the truck to start pushing. Setup can get tricky so it’s hard to say. Try the 2t2s.
Last edited by Mcran; 05-26-2008 at 07:26 AM.