R/C Tech Forums - View Single Post - Tamiya TRF415
Thread: Tamiya TRF415
View Single Post
Old 05-23-2008, 02:40 PM
  #19790  
TryHard
Tech Champion
iTrader: (4)
 
TryHard's Avatar
 
Join Date: Jun 2004
Location: Adelaide, Australia
Posts: 5,387
Trader Rating: 4 (100%+)
Default
Originally Posted by 94eg!
I don't know if this is covered, but I found that the MSX-MRE comes with 7 "standard" ball-nuts (BC2), and 2 "short" ball-nuts (BB9). Yet the instructions make no mention of where the two "short" BB9 ball-nuts go.

I've read through the MSX-MRE addendum, it clearly shows the install of 8 of the standard length BC2 ones which is already 1 more than what's included. The 9th ball-nut would be for the servo saver, but that still leaves us with the question....

....WHERE EXACTLY DO THE TWO BB9's GO?

MSX-MRE manual for reference:
http://www.tamiya.com/english/rc/rcm...4trf415msx.pdf
The BB9's go on the steering rack. There should be a small addendum sheet in the box detailing this change. Everything else is as per the instructions.

HiH
Ed
TryHard is offline  
Reply