OK Guys - Check this out. I did some more test runs today. What I found is that if I make a pass at 1/2 throttle I can definately here it shift. Its a nice even shift with a SMALL drop in rpm's. If I hold it full throttle then it just shifts real fast with NO drop in RPM's. What needs adjusted?
I am adjusting the "shift adjustment screws" and NOT the set screws for the little ball bearings.
I am running the AE .15 engine..
I havent seen the issues on the diffs yet but I am guessing that will come from your post. I will probably cross that bridge when it comes tho...