You need to recalibrate the ESC for your new TX


3.1 Calibrating the Mamba 25 to YOUR transmitter:
IMPORTANT NOTE: Calibration is required for the very first use of the Mamba 25
or whenever used with a new/different transmitter.
The Mamba 25 contains a throttle calibration feature that you’ll want to use the first time you
power it up with a new/different transmitter. Performing this exercise will teach the
controller how your transmitter works.
• Disconnect battery
• Turn Mamba microswitch off
• Connect battery
• Mamba flashes all LED’s and rings once
• Apply full throttle
• Turn Mamba microswitch on
• Wait 2 seconds
• Mamba flashes green led and rings 4 times indicating full throttle measured
• Mamba flashes red led while beeping, indicating it’s time to push full brake
• Push full brake
• Wait 1 second
• Mamba flashes red led and rings 4 times indicating full brake measured
• Mamba flashes yellow led while beeping indicating its time for neutral
• Put trigger to neutral (center)
• Wait 1 second
• Mamba flashes yellow led and rings4 times indicating neutral measured
• Wait for 1 second
• Mamba will flash all LED’s while and ring twice indicating that it is armed