R/C Tech Forums - View Single Post - Fantom Nitro Engines
View Single Post
Old 07-19-2003, 11:20 PM
  #11  
Old Skool
Tech Regular
 
Old Skool's Avatar
 
Join Date: Nov 2001
Location: SF Bay Area
Posts: 342
Default

I know I'm a little late to this thread, but after having no luck finding a TRX 2.5 to stick in my Super Nitro, I picked up up an 03 Fantom .15. You're right about the slide carb, but what I did was to bring out the "Motivator" (ie, my Dremel) and remove just enough plastic (stock upper deck) to allow slide clearance without having to resort to p/s engine mounts. I tweaked an old hand-ported CEN header enough to clear the rear tire and idled a tank of 20% through @ 220F. No time to run it, but will do so at the local track during practice tomorrow.

PS: Are you sure it's ABSC and not just ABC?
Old Skool is offline