R/C Tech Forums - View Single Post - Castle Creations Mamba/MM/MMM FACTORY Q&A thread!
Old 04-24-2008, 03:52 PM
  #1393  
LOW ET
Tech Elite
iTrader: (109)
 
LOW ET's Avatar
 
Join Date: Dec 2007
Location: cleveland, ohio
Posts: 3,290
Trader Rating: 109 (100%+)
Default

Originally Posted by wyd
Looks pretty good. Just keep tabs on the motor temp but at this time you should be good.
took the t4 out again and ran it until the lipo cutoff kicked in to check run time, it went 10 minutes. what's the average length of a race, 5-6 minutes? the battery and esc temps were ok but the motor hit 214* at the end of the 10 minute run. should i drop the pinion size to help the motor temp or if the race is only 5-6 minutes the temp should be below 200*?
LOW ET is offline