Originally Posted by
mrgsr
Hi guys, has anyone had issues with there clutch getting boggy in long finals?
I had my clutch set per the book with the exception of a yellow shoe and it would be fine in qualifiers but the car starts losing bottom end in finals.
I have switched to the kyosho 2d clutch to test in the nt1.
hey there mate..i have this experienced..1st you have to check on your centax spring,should not go below 8.95mm with preload tight like wht teamGP told.very important for you to get this right since your layout is quite big i presume..takecare of the 3 centrifugals,sometimes you might find it damaged at the holes,then you should get new 1 especially when you are having big clutch gap,i advice dont go futher than 0.6mm,just gona cut short the centrifugal&trust bearing lifetime..endplay also..the stronger your engine torque,less endplay better.play around with various spring types and spring nut pre-set.
apply drop of threadlock right after you get the spring nut tighten correctly.
