yep, have already set mode 1 on the ESC to value 2, there was no difference.
on both ESCs i have tried 2 motors but the 13.5T didnt work on the new ESC when the older 3.5T one did (but has now stopped).
i'm not 100% confident the sensor wires are the problem, because i have tried 3 different ones and all the same issue. however, what i did observe was when the motor worked and you took out the sensor wire, it has the same symptom as what is happening now (ie. no motor function, beeping/whining noise etc).
now, the new bit is cleaning the sensor...
does anyone have a picture of an LRP motor's insides to show me where the sensor would be located?
oh and i'm also going to try changing the capacitor...
i've read in a magazine of ppl using 2700uF 16V capacitors. to my way of thinking (level of experience and knowledge) as long as the voltage rating is higher than the packs i'm running then i'm fine, but the bigger the uF rating the better/longer/whatever it will work.
does anyone know what the TC Spec originally comes with?
are there any recommended replacements?
I`v seen a few X-11 spin the grease from the bearing onto the sensor...
Remove the rotor from the can and use a Q-tip to clean the sensor inside..
just wipe it off, no cleaner , ect...
It is made of black plastic and surrounds the top of the rotor inside the endbell...