Originally Posted by
gearhead13
I just got a picco 2607 pipe for my red dot and 710.
It is a REALLY tight fit, the front of the pipe nearly hits the front tire and tie rod. Also, the exhaust mount spring isnt long enough. If I move the front of the pipe outwards it likely will hit the tire and tie rod.
The pipe didnt come with a header to pipe silicone gasket, I had to modify one, and it leaks mostly because the front of the pipe is at a different angle than the header.
Can I just bend the header?
Anyone have the same problems?
suggestions?
I have a RRR, so when I comment, keep that in mind.
The pipe is quite long, so they are a tight fit from hitting the steering linkage.
I obviously can't see what came with your engine, but the exhaust mount spring is on the shorter side, but does fit.
Your pipe only came with one gasket? It should have come with two of the same gaskets. It goes on fairly easily over the engine exhaust outlet, but you have to stretch it over the manifold.