R/C Tech Forums - View Single Post - Associated Factory Team TC5, Brushless, LiPo, Li-ion Nanophosphate, Tips and Tricks
Old 03-24-2008, 01:32 PM
  #563  
fathead
Tech Addict
 
fathead's Avatar
 
Join Date: Sep 2003
Location: Auckland NZ
Posts: 621
Default

You can vary the amount of rebound by varying the position of the shock shaft when building them, if you want full rebound extend the shaft fully then roll the bladder on to the shock making sure to get all the air out then screw the cap on, to get less rebound put the shock shaft at say 50% extension the put the bladder on (making sure the shaft doesn't push out further as you put the bladder on), this will give you less rebound.

Lots of the factory guys appear not to be using any foam on top of the bladder, I only use the small one myself.
fathead is offline