I have a question. I am setting up a swift model. I have the motor installed.
I hooked up the esc with the red/black/white combo to the throttle. Then I ran my steering servo thats hooked up. I have a black/red wire set from the esc the instructions say to install it in the receiver in the battery position.
But it won't fit into the slot. The black wire should go to the negative side.
It will fit if i flip it and put the red wire to the negative side on the receiver.
What am I missing here? The receiver is a jr 3000 for a 2.4 ghz system. The
Black/red connector has a goofy type of fitting on it compare to the other esc connection.
Thanks
Dynodan22