Originally Posted by
Rockin Johny
AHHH!!! That is what I was afraid of. Milling the fins was my last resort. I can have that done pretty easily at work. Would you suggest taking them right off or just 1/2 the way to allow clearance? Will taking them right down allow enough cooling or is that even really an issue on the 4 cell set up ?
John
Before the GTB4 came out we just took the heat sink off and replaced it with an .032 or .063" aluminum plate. That's easier than machining the fins. I have even seen a few guys run without any heat sink at all, with the fets exposed, and haven't seen any smoke